Strength and Microstructure Analysis of Spot Welded Joints between a Sheet and a Nut of Different Steels

Authors

  • Vytautas JURGAITIS Kaunas University of Technology
  • Ramūnas ČESNAVIČIUS Kaunas University of Technology
  • Sigitas KILIKEVIČIUS Kaunas University of Technology
  • Romualdas DUNDULIS Kaunas University of Technology

DOI:

https://doi.org/10.5755/j01.mech.24.3.21027

Keywords:

spot welding, welded joints, welding parameters

Abstract

This study presents an investigation on the strength of spot welded joints between a plate made of DC01 steel and a non-standard nut made by cold forming of C22 steel. In order to determine the influence of the welding current on the quality of such welded joints, three types of test specimens were produced using different welding currents. The strength of the welded joints was studied and microstructural analysis was carries out as well as the hardness of the welded contacts was measured.

DOI: http://dx.doi.org/10.5755/j01.mech.24.3.21027

Author Biographies

Ramūnas ČESNAVIČIUS, Kaunas University of Technology

Department of Mechanical Engineering, Assoc. Prof. Dr.

Sigitas KILIKEVIČIUS, Kaunas University of Technology

Department of Transport Engineering, Assoc. Prof. Dr.

Romualdas DUNDULIS, Kaunas University of Technology

Department of Mechanical Engineering, Prof. Dr.

Downloads

Published

2018-06-27

Issue

Vol. 24 No. 3 (2018)

Section

MECHANICS OF SOLID BODIES