Vol 20, No 6 (2014)

Table of Contents

MECHANICS OF SOLID BODIES

Stress intensity factors for micro-crack emanating from micro-cavity in cement of reconstructed acetabulum PDF
N. Bounoua, A. Belarbi, M. Belhouari, B. Bachir Bouiadjra 527-534
Automotive stabilizer bar – stabilizer bar strength calculations using FEM, ovalization of radial areas of tubular stabilizer bars PDF
A. M. Wittek, D. Gąska, B. Lazarz, T. Matyja 535-542
The fiber volume fraction influence on mechanical properties of multi-layered carbon tubes PDF
S. Baskutis, M. Nariūnas, J. Baskutienė 543-549

MECHANICS OF FLUIDS AND GASES

Modeling of heat and mass transfer processes in phase transformation cycle of sprayed water into gas: 1. The calculation peculiarities of droplet phase transformation parameters PDF
G. Miliauskas, M. Maziukienė 550-558

DYNAMICS OF MECHANICAL SYSTEMS

Classification of vectors forms dedicated to bearings fault detection of electrical machines based on PSO algorithm PDF
Abla Bouguerne, Abdesselam Lebaroud 559-565
Research on the dynamics of single-acting crank pump with damless hydro turbine drive PDF
K. Bissembayev, D. Kinzhebayeva 566-572
Research of rotary piezotable driven by two harmonic signals PDF
I. Grybas, A. Bubulis, R. Bansevičius, V. Jūrėnas 573-576

DESIGN AND OPTIMIZATION OF MECHANICAL SYSTEMS

Terms of geometric action of rotating ball follower PDF
Maciej Kuchar 577-581

MECHANICAL TECHNOLOGIES

Assessment wind field in the region of Annaba East Algeria with an aerodynamic analysis for installation a small wind turbines PDF
N. Zerari, A. Benretem 582-589
Experimental analysis and numerical simulation of the stainless AISI 304 steel friction drilling process PDF
P. Krasauskas, S. Kilikevičius, R. Česnavičius, D. Pačenga 590-595
Vibrational excitation of a work piece for drilling force reduction in brittle materials PDF
V. Ostasevicius, V. Jurenas, G. Balevicius, M. Zukauskas, M. Ubartas 596-601
Investigation of abrasive water jet cutting parameters influence on 6082 aluminium alloy surface roughness PDF
V. Gylienė, V. Jūrėnas, P. Krasauskas 602-606


Print ISSN: 1392-1207
Online ISSN: 2029-6983