Vol. 20 No. 6 (2014)

Published: 2015-02-09

MECHANICS OF SOLID BODIES

Stress intensity factors for micro-crack emanating from micro-cavity in cement of reconstructed acetabulum

N. Bounoua, A. Belarbi, M. Belhouari, B. Bachir Bouiadjra

527-534
- PDF
Automotive stabilizer bar – stabilizer bar strength calculations using FEM, ovalization of radial areas of tubular stabilizer bars

A. M. Wittek, D. Gąska, B. Lazarz, T. Matyja

535-542
- PDF
The fiber volume fraction influence on mechanical properties of multi-layered carbon tubes

S. Baskutis, M. Nariūnas, J. Baskutienė

543-549
- PDF

MECHANICS OF FLUIDS AND GASES

Modeling of heat and mass transfer processes in phase transformation cycle of sprayed water into gas: 1. The calculation peculiarities of droplet phase transformation parameters

G. Miliauskas, M. Maziukienė

550-558

DYNAMICS OF MECHANICAL SYSTEMS

Classification of vectors forms dedicated to bearings fault detection of electrical machines based on PSO algorithm

Abla Bouguerne, Abdesselam Lebaroud

559-565
- PDF
Research on the dynamics of single-acting crank pump with damless hydro turbine drive

K. Bissembayev, D. Kinzhebayeva

566-572
- PDF
Research of rotary piezotable driven by two harmonic signals

I. Grybas, A. Bubulis, R. Bansevičius, V. Jūrėnas

573-576
- PDF

DESIGN AND OPTIMIZATION OF MECHANICAL SYSTEMS

Terms of geometric action of rotating ball follower

Maciej Kuchar

577-581
- PDF

MECHANICAL TECHNOLOGIES

Assessment wind field in the region of Annaba East Algeria with an aerodynamic analysis for installation a small wind turbines

N. Zerari, A. Benretem

582-589
- PDF
Experimental analysis and numerical simulation of the stainless AISI 304 steel friction drilling process

P. Krasauskas, S. Kilikevičius, R. Česnavičius, D. Pačenga

590-595
- PDF
Vibrational excitation of a work piece for drilling force reduction in brittle materials

V. Ostasevicius, V. Jurenas, G. Balevicius, M. Zukauskas, M. Ubartas

596-601
- PDF
Investigation of abrasive water jet cutting parameters influence on 6082 aluminium alloy surface roughness

V. Gylienė, V. Jūrėnas, P. Krasauskas

602-606
- PDF