Vol. 21 No. 6 (2015)

Published: 2016-01-19

MECHANICS OF SOLID BODIES

Investigating the Effect of Passes Number on Microstructural and Mechanical Properties of the Al2024/SiC Composite Produced by Friction Stir Processing

D. Ghanbari, M. Kasiri Asgharani, K. Amini

430-436
- PDF
Investigation of cutting tool diameter influencing wire cutting operation accuracy using several matrix configurations.

Romualdas Dundulis, Rytis Bortkevičius

437-442
- PDF
Interpretation of parameters in strain energy density bone adaptation equation when applied to topology optimization of inert structures

Emil Nuțu

443-449
- PDF

MECHANICS OF FLUIDS AND GASES

Numerical modelling of the hydrodynamic behaviour of the couple... piston-liner

A. Soualmia, M. Bouchetara

450-456
- PDF
Heat transfer enhancement in a fin and tube heat exchanger with isosceles vortex generators

D. Sahel, R. Benzeguir, T. Baki

457-464
- PDF

DYNAMICS OF MECHANICAL SYSTEMS

Optimum Design of Damped Vibration Absorber for Viscoelastic Bladed Disk Assemblies

Amir Abdollah Ghaderi, Alireza Mohammadzadeh, Mansour Nikkhah Bahrami

465-471
- PDF
Damage detection and localization in composite beam structures based on vibration analysis

Samir Khatir, Idir Belaidi, Roger Serra, Magd Abdel Wahab, Tawfiq Khatir

472-479
- PDF

DESIGN AND OPTIMIZATION OF MECHANICAL SYSTEMS

Addendum modification of spur gears with equalised efficiency at the points where the meshing stars and ends.

Antal Tiberiu Alexandru

480-485
- PDF

MECHANICAL TECHNOLOGIES

Practical aspects of increasing workers efficient work time in a high noise level industrial area

Robertas Mikalauskas, Vitalijus Volkovas

486-492
- PDF
Data-driven simulations of flank wear of coated cutting tools in hard turning

Ahmet Cakan, Fatih Evrendilek, Vedat Ozkaner

500-505
- PDF
The modelling of the compression ignition engine powered with diesel fuel with LPG admixture

Grzegorz Pulawski, Dariusz Szpica

493-499
- PDF