Statistical research on forming of threaded holes in thin plates

Authors

  • P. Krasauskas Kaunas University of Technology
  • S. Kilikevičius Kaunas University of Technology
  • R. Česnavičius Kaunas University of Technology
  • R. Dundulis Kaunas University of Technology

DOI:

https://doi.org/10.5755/j01.mech.22.3.15263

Abstract

This paper presents an investigation of the influence of machining data and workpiece thickness on drilling forces and moments during holes and treads forming in thin plates along with a multifactor linear regression analysis of the results. The research allows to predict optimal parameters for holes and treads forming in thin plates in order to optimise the drilling and tapping force along with the torque and, as a consequence, to decrease tool wear and extend the lifetime of the tools.

DOI: http://dx.doi.org/10.5755/j01.mech.22.3.15263

Downloads

Published

2016-06-13

Issue

Vol. 22 No. 3 (2016)

Section

MECHANICAL TECHNOLOGIES

License

The copyright for the articles in this journal is retained by the author(s) with the first publication right granted to the journal. The journal is licensed under the Creative Commons Attribution License 4.0 (CC BY 4.0).