A hole in the Vacuum Hose of a Vehicle Provides Lower Differences in Brake Measurements by the Ministry of Transport Brake Testers Rather Than the Characteristics of the Tester Used.

Authors

  • Carolina Senabre Universidad Miguel Hernández Deparment of Mechanical Enginering
  • Sergio Valero Universidad Miguel Hernández
  • Emilio Velasco Universidad Miguel Hernández

DOI:

https://doi.org/10.5755/j01.mech.24.2.17752

Keywords:

Ministry of transport, Vacuum Servo, Brake boosting system, brake testers characteristics

Abstract

In this research it is studied how vary brake measurement of a vehicle at Ministry of transport facilities when there is a hole in the vacuum hose of the brake booster. Data of brake with the brake boosting system in bad conditions is compared with results of brake of the same repaired vehicle tested on three different roller bed testers from the Maha brand.  Finally, the Efficiency of passing the test with and without the hole in the vacuum hose is calculated to see differences.

DOI: http://dx.doi.org/10.5755/j01.mech.24.2.17752

Author Biographies

  • Carolina Senabre, Universidad Miguel Hernández Deparment of Mechanical Enginering
    PHD Full time Proffessor
  • Sergio Valero, Universidad Miguel Hernández

    Departamento Ingeniería Mecánica y Energía

    phd proffessor
  • Emilio Velasco, Universidad Miguel Hernández

    Departamento Ingeniería Mecánica y Energía

     

    phd proffessor

Downloads

Published

2018-05-02

Issue

Vol. 24 No. 2 (2018)

Section

MECHANICAL TECHNOLOGIES

License

The copyright for the articles in this journal is retained by the author(s) with the first publication right granted to the journal. The journal is licensed under the Creative Commons Attribution License 4.0 (CC BY 4.0).