Case Study on Numerical Calculation of a Disc Bush in the Disc Harrow in the Welding Version

-

Authors

  • Paweł LONKWIC The State School of Higher Education
  • Ireneusz USYDUS The Institute of Technical Sciences and Aviation
  • Arkadiusz TOFIL The Institute of Technical Sciences and Aviation
  • Tomasz KRAKOWSKI AGH University of Science and Technology
  • Hubert RUTA AGH University of Science and Technology
  • Daniel PIENIAK University of Economics and Innovations in Lublin

DOI:

https://doi.org/10.5755/j02.mech.28233

Keywords:

disc harrow, optimization, FEM, production process, weld-ing process, agricultural machinery

Abstract

The optimization of production processes in companies comes down to two main measures influencing the economic factor. The first one is the reduction of interval micro-periods between operations, and the second is to use post-production waste as much as possible. These treatments apply to virtually all industries regardless of the final product effect. This article describes the application of a special welding device for welding the workpiece with a bush type, designed for fixing the plate in the plate gun. As a result of its application, a significant reduction of time needed to produce one bush has been achieved, and thus the amount of time in a unit of time has been increased. As part of the implementation work, the bush design changes were also made, which made it possible to reduce post-production waste not suitable for current production, but allowing its use for other purposes. The results of the work were implemented in the company producing agricultural machinery in Lublin.

Downloads

Published

2021-12-10

Issue

Vol. 27 No. 6 (2021)

Section

MECHANICAL TECHNOLOGIES