Experimental Study of Vibration Isolation Using Electromagnetic Damping

Authors

  • Easu DAKSHNAMOORTHY KCG College of Technology
  • Ralph KCG College of Technology
  • Sarang KCG College of Technology
  • Siddharth KCG College of Technology

DOI:

https://doi.org/10.5755/j02.mech.34759

Keywords:

Electromagnets, Vibration isolation, nonlinear force, levitation, repulsive force

Abstract

This study presents an experimental investigation focused on the reduction of vibrations using electromagnetic damping techniques. The objective is to explore the effectiveness of electromagnetic damping in mitigating undesirable vibrations and enhancing system stability. A single-degree vertically constrained spring-mass system, two pairs of electromagnets, Lab VIEW software, an accelerometer, DAQ card were used for the experimentation. SWG 17 and SWG19 coil electromagnets were used in different conditions of energization to evaluate the effectiveness of the electromagnetic damping system. The parameters such as excitation frequency, vibration amplitude, and electromagnetic damping force are systematically varied and their effects on vibration isolation are analysed. The results demonstrate that the electromagnetic damping system effectively isolates base induced vibrations across a range of frequencies and amplitudes. The experimental data reveal  that at lower frequencies, upto 6Hz the amplitude of RMS acceleration was same as that of the system without energizing the electromagnet and at higher frequencies, above 10 Hz, all 2V,4V and 6V of energized electromagnets in the SDVC system  showed negligible  variation in the  RMS amplitude of acceleration. A substantial isolation of top plate was observed at higher frequencies of base excitation.

 

 

Downloads

Published

2024-04-23

Issue

Section

DYNAMICS OF MECHANICAL SYSTEMS