INFLUENCE OF BOUNDARY CONDITIONS ON THE VIBRATION MODES OF SMART TURNING TOOL

Authors

  • M. Vaičekauskis Kaunas University of Technology
  • R. Gaidys Kaunas University of Technology
  • V. Ostaševičius Kaunas University of Technology

DOI:

https://doi.org/10.5755/j01.mech.19.3.4373

Keywords:

smart tool, mode control, harmonic response

Abstract

The paper presents analysis of vibration modes of a high-frequency assisted turning tool. The analysis was performed with different locations of contact areas positions. Turning tool contact area set was found in which tool modes overlap or localize. Also it was conducted periodic turning tool response analysis to periodic impact. The analysis was caried out with three diferent contact area sets and it was concluded that when using fifth conctact area set longitudinal turning tool modes are dominant and the frequency amplitude is the biggest.

DOI: http://dx.doi.org/10.5755/j01.mech.19.3.4373

Downloads

Published

2013-06-20

Issue

Vol. 19 No. 3 (2013)

Section

DYNAMICS OF MECHANICAL SYSTEMS