EFFECT OF THE ATTACHMENT OF THE BALLISTIC SHIELDS ON MODELLING THE PIERCING PROCESS

Authors

  • K. Jamroziak Gen. Tadeusz Kosciuszko Miltary Academy of Land Forces
  • M. Bocian Wroclaw University of Technology
  • M. Kulisiewicz Wroclaw University of Technology

DOI:

https://doi.org/10.5755/j01.mech.19.5.5536

Keywords:

ballistic shields, modelling of punching process

Abstract

The article discusses issues related to the process of piercing the material at high speed of ballistic impact. The analysis assumes the dynamic degenerate model that takes into account the dry friction. On the basis of the adopted parameters of the dynamical model of piercing the material, constants were identified, which value can strongly influence the attachment of the shield. Such an approach can be considered as an introduction to synthesis of methods for identification of dynamic loads using degenerate models.

DOI: http://dx.doi.org/10.5755/j01.mech.19.5.5536

Downloads

Published

2013-10-23

Issue

Vol. 19 No. 5 (2013)

Section

DYNAMICS OF MECHANICAL SYSTEMS

License

The copyright for the articles in this journal is retained by the author(s) with the first publication right granted to the journal. The journal is licensed under the Creative Commons Attribution License 4.0 (CC BY 4.0).