Mechanical properties of shaft surfacing with micro-jet cooling

Authors

  • Tomasz Wegrzyn Silesian University of Technology Faculty of Transport str. Krasinskiego 8 40-019 Katowice
  • Jan Piwnik Bialystok University of Technology Mechanical Faculty str. Wiejska 45C 15-351 Bialystok
  • Bogusław Lazarz Silesian University of Technology Faculty of Transport str. Krasinskiego 8 40-019 Katowice
  • Wojciech Tarasiuk Bialystok University of Technology Mechanical Faculty str. Wiejska 45C 15-351 Bialystok

DOI:

https://doi.org/10.5755/j01.mech.21.5.9545

Keywords:

welding surfacing, micro-jet cooling, metallographic structure, wearing

Abstract

An article presents information about innovate welding technology (surfacing) with micro-jet cooling. There are given main information about parameters of shaft surfacing with micro-jet cooling process. There were also put down information about influence of various micro-jet gases on metallographic structure of machine shaft after surfacing. There were tested tribological properties of welds. The tribological interactions of a solid shaft surfaces were tested after welding with micro-jet cooling.

DOI: https://dx.doi.org/10.5755/j01.mech.21.5.9545

Author Biographies

  • Tomasz Wegrzyn, Silesian University of Technology Faculty of Transport str. Krasinskiego 8 40-019 Katowice

    Associate professor

    Department of Automotive Vehicle Service

  • Jan Piwnik, Bialystok University of Technology Mechanical Faculty str. Wiejska 45C 15-351 Bialystok

    Professor

    Department of Technology Equipment and Materials

  • Bogusław Lazarz, Silesian University of Technology Faculty of Transport str. Krasinskiego 8 40-019 Katowice

    Professor

    Department of Automotive Vehicle Construction

     

  • Wojciech Tarasiuk, Bialystok University of Technology Mechanical Faculty str. Wiejska 45C 15-351 Bialystok

    Assistant Professor

    Department of Applied Mechanics and Computer Science

Downloads

Published

2015-10-16

Issue

Section

MECHANICAL TECHNOLOGIES