Research on Complex Product Parts Matching by using Improved Taguchi Method

Authors

  • Fengque PEI Hohai University
  • Yifei TONG Nanjing University of Science & Technology
  • Minghai YUAN Hohai University
  • Haojie SONG Nanjing Research Institute of Electronic Engineering

DOI:

https://doi.org/10.5755/j02.mech.28182

Keywords:

Taguchi Methods; Dimension chains; GA; Improved Smaller-is-better Method

Abstract

With the development of intelligent manufacturing, the key strategic of complex equipment is becoming more and more obvious. How to realize the assembly of complex products has become the focus of intelligent manufacturing. This paper puts forward the improved Taguchi method to dimension chains measures, by using different quality loss function to different dimension chains, the cores are the Nominal-is-best, non-core is measured with the improved Smaller-is-better to improve convergence perusal and increase matching rate; General adopt Smaller-is-better to enhance assembly accuracy, reduce interference fit and assembly cost. Then the dimension chains quantitative model of complicated product assembly by using the signal-to-noise ratio and different weights is built up. The model contains modeling assumption, the objective function and the matching model. And this model is regard as the fitness function of genetic algorithm. Finally, the feasibility and efficiency of the scheme are verified by the case study.

Author Biography

Fengque PEI, Hohai University

School of Mechanical Engineering

Downloads

Published

2021-10-12

Issue

Section

DYNAMICS OF MECHANICAL SYSTEMS