BONDED END ANCHOR FOR STATOR TENSIONING RODS

Authors

  • S. Kuosmanen Lappeenranta University of Technology
  • H. Eskelinen Lappeenranta University of Technology
  • J. Varis Lappeenranta University of Technology

DOI:

https://doi.org/10.5755/j01.mech.19.5.5534

Keywords:

adhesively bonded, stator, composite, compressing method

Abstract

The presented paper investigates a novel method for binding stator steel sheets. The researched structure consists a composite based solution that acts like a com-pression spring. In this paper is presented a preliminary research for the end piece of the stator compression struc-ture. It was researched, if an adhesively bonded joint could be utilized.

DOI: http://dx.doi.org/10.5755/j01.mech.19.5.5534

Downloads

Published

2013-10-23

Issue

Vol. 19 No. 5 (2013)

Section

DESIGN AND OPTIMIZATION OF MECHANICAL SYSTEMS

License

The copyright for the articles in this journal is retained by the author(s) with the first publication right granted to the journal. The journal is licensed under the Creative Commons Attribution License 4.0 (CC BY 4.0).