Vol. 20 No. 2 (2014)

Published: 2014-04-22

MECHANICS OF SOLID BODIES

The third equilibrium equation for forces of flexural member cross-section

I. Židonis

127-134
- PDF
Determination of mixed-mode fracture characteristics due dynamic opening and in-plane shear cases

P. Šadreika, A. Žiliukas

135-139
- PDF
The extent of irregular stress distribution in a two-layer cylindrical bars subjected to the change of temperature

N. Partaukas, J. Bareišis

140-146
- PDF
Numerical analysis of the influence of the blast wave on the composite structure

W. Ogierman, G. Kokot

147-152
- PDF
Effect of volume fiber and crack length on interlaminar fracture properties of glass fiber reinforced polyester composites (GF/PO composites)

N. Mahmoudi

153-157
- PDF

MECHANICS OF FLUIDS AND GASES

Investigation of liquid viscosity influence on flow rate measurement by rotary vane meters

E. Maslauskas, N. Pedišius, G. Zygmantas

158-164
- PDF

DYNAMICS OF MECHANICAL SYSTEMS

Experimental research of vibratory alignment using passive compliance devices

B. Bakšys, J. Baskutienė, J. Vėžys

165-170
- PDF
Modified tool structures for effective cutting

V. Ostasevicius, V. Jurenas, A. Juskevicius

171-176
- PDF
Fault detection of washing machine with discrete wavelet methods

T. C. Akinci, S. S. Karabeyoglu, O. Yilmaz, S. Seker

177-182
- PDF
Active reduction of identified machine drive system vibrations in the form of multi-stage gear units

T. Dzitkowski, A. Dymarek

183-189
- PDF
Influence of elements dynamic cohesiveness in power shafting on torsional vibrations spreading and dynamic equality of reducible model

V. Shehovtsov, N. Sokolov-Dobrev, M. Lyashenko, P. Potapov, K. Shehovtsov, A. Kalmykov

190-196
- PDF

DESIGN AND OPTIMIZATION OF MECHANICAL SYSTEMS

Application of variational and FEM methods to the modelling and numerical analysis of guillotining process for geometrical and physical nonlinearity

L. Bohdal, L. Kukielka

197-204
- PDF

MECHANICAL TECHNOLOGIES

Temporal and frequential analysis of the tools wear evolution

M. K. Babouri, N. Ouelaa, A. Djebala

205-212
- PDF
Non-destructive test methods application for structure analysis of ultra-high performance concrete after deterioration of cyclic salt-scaling

V. Vaitkevičius, E. Šerelis, Ž. Rudžionis, D. Vaičiukynienė

213-220
- PDF
Simulation of concentration distribution of dispersed particles of magnetorheological fluid in the gap workpiece-tool of finishing polishing device

A. Mokeev, E. Korobko, A. Bubulis

221-225
- PDF
An analytical approach towards EHD analysis of connecting-rod bearing

A. Benhamou, A. Bounif, P. Maspeyrot, C. Mansour

226-233
- PDF
Integrated structure of manufacturing data for computer aided manufacturing engineering

R. Mankutė

234-240
- PDF