Vol 21, No 6 (2015)

Table of Contents

MECHANICS OF SOLID BODIES

Investigating the Effect of Passes Number on Microstructural and Mechanical Properties of the Al2024/SiC Composite Produced by Friction Stir Processing PDF
D. Ghanbari, M. Kasiri Asgharani, K. Amini 430-436
Investigation of cutting tool diameter influencing wire cutting operation accuracy using several matrix configurations. PDF
Romualdas Dundulis, Rytis Bortkevičius 437-442
Interpretation of parameters in strain energy density bone adaptation equation when applied to topology optimization of inert structures PDF
Emil Nuțu 443-449

MECHANICS OF FLUIDS AND GASES

Numerical modelling of the hydrodynamic behaviour of the couple... piston-liner PDF
A. Soualmia, M. Bouchetara 450-456
Heat transfer enhancement in a fin and tube heat exchanger with isosceles vortex generators PDF
D. Sahel, R. Benzeguir, T. Baki 457-464

DYNAMICS OF MECHANICAL SYSTEMS

Optimum Design of Damped Vibration Absorber for Viscoelastic Bladed Disk Assemblies PDF
Amir Abdollah Ghaderi, Alireza Mohammadzadeh, Mansour Nikkhah Bahrami 465-471
Damage detection and localization in composite beam structures based on vibration analysis PDF
Samir Khatir, Idir Belaidi, Roger Serra, Magd Abdel Wahab, Tawfiq Khatir 472-479

DESIGN AND OPTIMIZATION OF MECHANICAL SYSTEMS

Addendum modification of spur gears with equalised efficiency at the points where the meshing stars and ends. PDF
Antal Tiberiu Alexandru 480-485

MECHANICAL TECHNOLOGIES

Practical aspects of increasing workers efficient work time in a high noise level industrial area PDF
Robertas Mikalauskas, Vitalijus Volkovas 486-492
Data-driven simulations of flank wear of coated cutting tools in hard turning PDF
Ahmet Cakan, Fatih Evrendilek, Vedat Ozkaner 500-505
The modelling of the compression ignition engine powered with diesel fuel with LPG admixture PDF
Grzegorz Pulawski, Dariusz Szpica 493-499


Print ISSN: 1392-1207
Online ISSN: 2029-6983