Vol 17, No 2 (2011)

Table of Contents

MECHANICS OF SOLID BODIES

Fatigue life prediction for cyclically bent threaded connections PDF
Ž. Juchnevičius, A. Krenevičius 113-119
High-cyclic failure analysis of welded cast iron plates PDF
R. Stonkus, M. Leonavičius, G. Petraitis, S. Stupak 120-125
Application of strut-and-tie model on eccentric columns PDF
M. Frantova, P. Štemberk, V. Vala 126-131
Poisson's ratios influence on strength and stiffness of cylindrical bars PDF
N. Partaukas, J. Bareišis 132-138
Investigation of multilayered packages resistance to free fall on the solid surface PDF
L. Gegeckienė, E. Kibirkštis, V. Miliūnas, V. Volkovas 139-143

MECHANICS OF FLUIDS AND GASES

Heat transfer for film condensation of vapour PDF
S. Šinkūnas, A. Kiela 144-148
Numerical investigation of thermo-fluid dynamics of two triangular jets PDF
I. Chitsaz, B. Farhanieh 149-155
Numerical study on hydraulic and thermal characteristics of a minichannel heat sink with impinging air flow PDF
M. Beriache, A. Bettahar, L. Loukarfi, L. Mokhtar Saidia, H. Naji 156-161
Effects of VNT and IGV association on turbocharger centrifugal compressor performances PDF
L. Izidi, A. Liazid 162-167
Numerical study of a turbulent jet flow issued from lobed diffuser PDF
M. Boulenouar, A. Meslem, B. Imine, I. Nastase 168-171

DYNAMICS OF MECHANICAL SYSTEMS

DYNAMIC RESPONSE OF AXIALLY LOADED EULER-BERNOULLI BEAMS PDF
M. Bayat, A. Barari, M. Shahidi 172-177
Dynamic simulations regarding the influence of the load-rigidity correlation on the working accuracy of a medical Triglide parallel robot PDF
N. R. Rat, M. Neagoe, D. Diaconescu, S. D. Stan 178-181

DESIGN AND OPTIMIZATION OF MECHANICAL SYSTEMS

Hybrid numerical-experimental investigation of two-degree-of-freedom piezoelectric positioning actuator PDF
R. Bansevičius, S. Telksnytė, G. Janušas, A. Palevičius 182-186
Design optimization of square aluminium damage columns with crashworthiness criteria PDF
H. R. Allahbakhsh, J. Saemi, M. Hourali 187-192
Numerical simulation of a flow around an unmanned aerial vehicle PDF
S. M. A. Meftah, B. Imine, O. Imine, L. Adjlout 193-196

MECHANICAL TECHNOLOGIES

Wear resistant layers obtained by using materials powder for overlay welding structural steel PDF
P. Ambroza, L. Kavaliauskienė 197-202
Modification of rapeseed oil with free fatty acids PDF
J. Padgurskas, R. Kreivaitis, A. Kupčinskas, A. Žunda 203-207
Characterization of various coatings in terms of friction and wear for internal combustion engine piston rings PDF
A. Guermat, G. Monteil, M. Bouchetara 208-215
Chronicle PDF
  216-219


Print ISSN: 1392-1207
Online ISSN: 2029-6983